DataCard LM200, Руководство пользователя

Страница: 26 / 138

16 Using the Printer and Laminator
Loading Retransfer Film
1.
Slide the door latch up and open the printer door (1).
2.
Press the retransfer film release button and remove the
green cartridge (2).
3.
Remove both used film spools from the cartridge (if
present).
4.
Load the new roll of retransfer film on the cartridge:
a.
Put the full roll of film on the green supply spindle
(A).
b.
Put the empty take ‐ up spool on the black take ‐ up
spindle (B).
c.
Align film along the three film guides.
d.
Wind two frames of film onto the take ‐ up spool
(D). Set the film so that a black frame line is
positioned next to the film guide, as shown on the label inside the cartridge.
e.
Take up any slack by turning the take ‐ up knob
clockwise. Gently pull the take ‐ up knob and turn.
If slack cannot be removed, verify that the supply
and take ‐ up spools are firmly seated on the
spindles.
To ease inserting into the printer, the film must
be tight along the film guides. Turning the supply
and take ‐ up knobs helps maintain the proper
tension.
5.
Replace the loaded film cartridge in the printer until it
clicks into position (5).
6.
Close the printer door (6).
The retransfer film cartridge cannot be loaded if the
printer is in transport mode. Power on the printer
until it displays an error, and then power it off again
to cancel transport mode, if necessary.
1
2
E
6
5