DataCard LM200, Руководство пользователя

Страница: 109 / 138

SR200 & SR300 Card Printers and LM200 & LM300 Laminators User’s Guide 99
Laminator LCD Messages
This table describes the laminator messages that may be displayed on the printer LCD panel:
MG Mechanical There is a magnetic stripe
mechanical error.
Power the printer off and then on again. Call for
service if the problem persists.
MG Hardware There is a magnetic stripe
hardware error.
Power the printer off and then on again. Call for
service if the problem persists.
MG Test Err A write error occurred
during self ‐ test.
1.
Verify that the type and orientation of
magnetic cards in the card hopper is correct,
as described in “Loading Cards” on page 12 .
2.
Press Reset and then to initialize the
printer.
LCD Message Possible Cause Solution
Jam (In) There is a card jam in the
entrance area.
Make sure that the laminator is properly
connected to the printer as described in
“Checking the Laminator Connection” on
page 20 .
Refer to “Clearing a Card Jam” on page 91 to
clear the jam.
Jam (Middle) There is a card jam near
the heating roller.
The laminating temperature is too high or the
speed is too slow. Set the temperature or speed
as described in “Laminator Tab” on page 47 .
Refer to “Clearing a Card Jam” on page 91 to
clear the jam.
Jam (Out) There is a card jam in the
card discharge area.
The laminating temperature is too high or the
speed is too slow. Set the temperature or speed
as described in “Laminator Tab” on page 47 .
Refer to “Clearing a Card Jam” on page 91 to
clear the jam.
Film ‐ B RunOut The end of the roll mark
has been detected.
Replace the laminating material as described in
“Loading Top ‐ Side Laminate Film” on page 17 .
Printer LCD Message Possible Cause Solution