DataCard LM200, Руководство пользователя

Страница: 22 / 138

12 Using the Printer and Laminator
Before You Begin
Make sure that the printer and laminator (if used) are set up and the printer driver installed.
Refer to the Datacard SR200 & SR300 Card Printers and LM200 & LM300 Laminators Installation
Guide for instructions.
Create the card design(s) to use, and test each design before beginning production. Be sure to
use production card stock, and test all data and all processes. For example:

Encode and read magnetic stripe data, if used.

Print and verify the colors and quality of printing.

Laminate test cards and make sure that the results meet your requirements.
Ask your service provider for assistance, if needed, to make your design work.
Loading Supplies
Before using the printer, make sure that the correct cards have been loaded into the card hopper,
that ink ribbon and retransfer film cartridges are installed in the printer, and that (if used)
laminate film cartridge(s) are loaded in the laminator.
Loading Cards
The card hopper can hold up to 100, 0.030 inch (0.75 mm) cards. The cards are held in position
with a hopper cover. Make sure that magnetic stripe cards or smart cards are loaded in the
proper orientation for processing.
1.
Slide the card hopper latch open (1).
2.
Slide the hopper cover up (2).
If the printer uses the security lock, refer to “Security Lock Tab” on page 49 . Unlock the
printer before starting any of the tasks in this chapter.