Danfoss VLT HVAC Drive FC 102, Руководство по программированию, Страница: 17 / 250

Menu key
[Menu]
Select 1 of the following modes:
•
Status
•
Quick Setup
•
Main Menu
Main Menu is used for programming all parameters.
The parameters can be accessed immediately unless a
password has been created via:
•
Parameter 0-60 Main Menu Password ,
•
Parameter 0-61 Access to Main Menu w/o Password ,
•
Parameter 0-65 Personal Menu Password ,
•
Parameter 0-66 Access to Personal Menu w/o
Password
.
Quick Setup is used to set up the frequency converter
using only the most essential parameters.
The parameter values can be changed using the [
▼
] [
▲
]
when the value is flashing.
Select
Main Menu by pressing the [Menu] key a number of
times until the Main Menu LED is lit.
Select the parameter group [xx-__] and press [OK].
Select the parameter [__-xx] and press [OK].
If the parameter is an array parameter select the array
number and press [OK].
Select the wanted data value and press [OK].
Press [Back] to step backwards.
Arrow [
▼
] [
▲
] keys are used for manoeuvring between
parameter groups, parameters, and within parameters.
Press [OK] is used for choosing a parameter marked by the
cursor, and for enabling the change of a parameter.
Illustration 2.16 Menu Display
Operation Keys
Keys for local control are found at the bottom of the
control panel.
130BP046.10
Hand
on
Off
Auto
on
Reset
Illustration 2.17 Operation Keys of the Numerical LCP (NLCP)
[Hand On] enables control of the frequency converter via
the LCP. [Hand On] also starts the motor. Press the
navigation keys [
▲
]/[
▼
]/[
►
]/ [
◄
] to enter motor speed
data. The key can be selected as [1] Enable or [0] Disable
via parameter 0-40 [Hand on] Key on LCP .
External stop signals activated by control signals or a serial
bus override a start command via the LCP.
The following control signals are still active when [Hand
on] is activated:
•
[Hand On] - [Off] - [Auto On]
•
Reset
•
Coasting stop inverse
•
Reversing
•
Set-up select lsb - Set-up select msb
•
Stop command from serial communication
•
Quick stop
•
DC brake
[Off] stops the connected motor. The key can be selected
as
[1] Enable or [0] Disable via parameter 0-41 [Off] Key on
LCP .
If no external stop function is selected and the [Off] key is
inactive, the motor can be stopped by disconnecting the
mains supply.
[Auto On] enables the control terminals and/or serial
communication to control the frequency converter. When a
start signal is applied on the control terminals and/or the
bus, the frequency converter starts. The key can be
selected as
[1] Enable or [0] Disable via
parameter 0-42 [Auto on] Key on LCP .
NOTICE
An active HAND-OFF-AUTO signal via the digital inputs
has higher priority than the control keys [Hand On] [Auto
On].
[Reset] is used for resetting the frequency converter after
an alarm (trip). It can be selected as
[1] Enable or [0]
Disable via parameter 0-43 [Reset] Key on LCP .
How to Programme Programming Guide
MG11CE02 Danfoss A/S © 03/2015 All rights reserved. 15
2 2