Daikin RXYQ-TA Series, Руководство по обслуживанию, Страница: 55 / 337

SiUS341615E MAIN/SUB Setting
Remote Controller 42
3.2 Wireless Remote Controller
Introduction
To set the wireless remote controller, you have to set the address for:
„
The receiver of the wireless remote controller
„
The wireless remote controller.
Setting the Address for the Receiver
The address for the receiver of the wireless remote controller is factory setting to 1. To change this setting,
proceed as follows:
Set the wireless address switch (SS2) on the PCB according to the table below.
When using both a wired and a wireless remote controller for 1 indoor unit, the wired controller should be set to
MAIN. Therefore, set the MAIN/SUB switch (SS1) of the receiver to SUB.
Setting the Address for the Wireless Remote Controller
The address for the wireless remote controller is factory setting to 1. To change this setting, proceed as follows:
1. Hold down the button and the button for at
least 4 seconds to get the Field setting mode.
(Indicated in the display area in the figure at right.)
2. Press the button and select a multiple setting (A/b).
Each time the button is pressed the display switches between A
and b .
3. Press the button or button to set the address.
Address can be set from 1 to 6, but set it to 1 ~ 3 and to same
address as the receiver. (The receiver does not work with
address 4 ~ 6.)
4. Press the button to enter the setting.
5. Hold down the button for at least 1 second to quit the
Field setting mode and return to the normal display.
Unit No. No. 1 No. 2 No. 3
Wireless address
switch (SS2)
MAIN/SUB MAIN SUB
MAIN/SUB
switch (SS1)
1 2 3
1 2 3
1 2 3
S
M
S
M
Mode
3
2
4
1
Address
5
Multiple
setting
1 2 3 4 5 6