Daikin BRC1E71, Инженерные данные

Страница: 19 / 46

Operation Manual EDUS72-975
18 BRC1E71
3P243520-2C
16
English
Basic Operation
Setting the Cool / Heat Changeover Master
(VR
V only)
Setting Changes
See page 18 for an explanation of the cool/heat changeover master indoor unit.
1
Cool
Return
Setting
Set to
Cool
74
F
Cool
Return
Setting
Set to
Cool
74
F
MASTER
CONTROLLED
Press the Operation Mode Selector button
Ɣ
on the remote controller of the changeover master indoor unit for at least four seconds. (While the backlight is illuminated) The “
Ɣ
MASTER
CONTROLLED
” icon on each remote controller for the
indoor units connected to the same outdoor unit or BS unit will start fl
ashing.
V
ent mode setting changes are possible regardless of the cool/
*
heat changeover master indoor unit. If cool/heat mode is confi
gured for control from the outdoor unit,
*
all remote controllers serving the associated indoor units will display its “
MASTER
CONTROLLED
”
icon.
Set the cool/heat changeover master indoor unit as
Ɣ
outlined below
.
The icon “ ” will flash on all remote controllers when the power is turned ON for the first time.
Selection Settings
MASTER
CONTROLLED
2
Cool
Return
Setting
Set to
Cool
74
F
MASTER
CONTROLLED
Cool
Return
Setting
Set to
Cool
74
F
Press the Mode Selector button on the
Ɣ
remote controller of the indoor unit which is to serve as the cool/heat changeover master
.
The remote controller for the changeover master indoor unit is established and the
MASTER
CONTROLLED
icon disappears.
Other remote controllers in the system (indoor units served by the same outdoor unit or indoor units served by the same branch selector (BS) unit) will now display the
MASTER
CONTROLLED
icon.
01_EN_3P243520-2C.indd 16
8/27/2009 1:48:35 PM
English
15
V
entilation Mode
When the Indoor Unit is Interlocked with Energy Recovery V
entilator
Preparation
For equipment protection purposes, apply power to the outdoor units at least six hours before
Ɣ
starting the operation of the system.
Operation
1
V
ent
Return
Setting
AUT
O
ER
V
When operating the energy recovery
Ɣ
ventilator (ER
V) between seasons
without the air conditioner
, set the
control to ventilation mode.
2
Changes to the ventilation mode are made from the
Ɣ
main menu.
V
entilation Mode:
Auto, ER
V
, and Bypass
*
3
Changes to the ventilation rate are made from the
Ɣ
main menu.
V
entilation Rate: Low or High
*
4
On/Off
n
u
K
Press On/Of
f button.
Ɣ
The Operation lamp (green) will illuminate and the system will start operating.
5
On/Off
n
u
K
When the On/Of
f button is pressed
Ɣ
again, the system will stop operating and the operation lamp will turn of
f.
01_EN_3P243520-2C.indd 15
8/27/2009 1:48:34 PM