－
57
－
10. OPERATION
(Continued)
[3] Deletion of Memory
The welding conditions stored can be deleted. You can delete all stored welding conditions
at one time or delete them one by one.
●
Deletion Method
(1) Turn off the power switch, and then turn on the power switch with LOAD key[12] and SAVE
key[13] pressed down at the same time. After power-up, the left display meter will display
“dEL” as shown in the figure below. If so, release all keys.
(2) Set the condition number to be deleted by using VOLTAGE adjusting knob[5]. When
rotating the knob counter-clockwise continuously, the right display meter will display
“ALL” as shown in the figure below, and all memory data may be deleted thereafter.
The setting to delete all memory data.
Note: If using the “ALL” setting to delete all memory data, the welding condition
being used will also be deleted. Therefore, all parameters will restore to their
initial setting.
(3) After pressing the ENTER key[14], “dEL” will be blinking. Confirm the correct number. If
the number is wrong, press any key other than the ENTER key to return to step (2) above.
To stop the deletion, shut off the power switch.
(4) Press ENTER key[14] again to delete the memory data corresponding to the specified
condition number. After data deletion, “End” will be displayed. Shut off the power switch
and then switch on it again.
Note: In a deletion mode, the data to be deleted will be erased permanently after
pressing the ENTER key twice. Confirm the condition number carefully to be
deleted before effecting the deletion.
Deletion Model “dEL” lighting
Blinking Condition Number to be deleted
“dEL” lighting
“ALL” blinking
Wminfo
