－
55
－
10. OPERATION
(Continued)
[2] LOAD Function
To read out the welding conditions stored in the JOB MEMORY of the welding power
source.
Note:
The welding condition being used will be overwritten by the welding
condition to be read. Store the current useful welding condition to be used
in the future by a condition number before reading.
●
Reading Method
(1) Press LOAD key[12] to switch to a read mode.
If the specified condition number has memory data stored, JOB No. and welding current of
the JOB No. will light up as shown in the figure below. For example, the right digital meter
will display a read mode code and condition number “L 1”, the “Job No.” LED will light up,
and the left display meter will display the setting welding current of “250” stored by the
condition number “1”. In this status, you can change JOB number by VOLTAGE adjusting
knob[5].
If the set condition number has no memory data, for example, the right display meter will
blink display a read mode code and condition number “L 1”, and the left display meter will
display “
―
―
―
”, as shown in the figure below. Select other JOB No.
(2) After select a JOB No., press ENTER key[14] to confirm data reading.
In this status, the setting value for each parameter of the welding condition to be read can
be confirmed by using DISPLAY CHANGE key[7]. The setting value for the selected
parameter will be displayed.
NOTE: In this status, the condition number and mode can not be changed. To set a
condition number again, press LOAD key[12] to return to the status shown in
section (1) above. To cancel this status, press SAVE key [13]to exit the read
mode.
(3) Press ENTER key[14] again to read out the memory data and end the read mode.
Read Mode
Condition Number
blinking
Setting value for
welding current stored
Wminfo
