－
42
－
10. OPERATION
(Continued)
10.1.11 Using the Analog Remote Control
This welding power source can be operated without supplied analog remote control.
When connecting the analog remote control to the power source, you can use it to adjust
welding current and voltage, and read welding condition near the working area.
The analog remote control is automatically recognized when it connected. In this state it takes
precedence, i.e., welding current and voltage can no longer be set from the operation panel
side. While being connected to the analog remote control, the settings of remote control are
displayed in the digital meters. The data set by the analog remote control will disappear
immediately after it is disconnected.
●
When making the INDIVIDUAL adjustment
When “INDIVIDUAL” is set (at the operation panel), welding current and voltage can be set
individually.
●
When making the SYNERGIC adjustment
When the “SYNERGIC” adjustment is set, welding voltage is automatically adjusted only by
turning the WELDING CURRENT knob[4]. Use the WELDING VOLTAGE knob to finely
adjust welding voltage.
The memorized welding conditions from the 11
th
to the 30
th
one can not be read out by using
the reading function of the analog remote control.
Remote: Affects the settings through Remote Control Box knobs.
LOAD: The stored welding conditions from the first to the tenth one can be
read by means of the knob on the left side
.
Panel of Analog Remote Control for CPVE-400/500
WELDING VOLTAGE adjusting
knob:
can be set by this welding
voltage setting knob.
The scales on the inner ring will
be used as benchmarks for
INDIVIDUAL ADJUSTMENT.
In the case of SYNAGIC
adjustment, aligning to mark
“
●
” achieves the standard
setting. Turn it to the right to
increase voltage, or to the left
to decrease voltage.
WELDING CURRENT
adjusting knob:
Use this knob to set a
welding current or
select JOB MEMORY
number.
INCHING SWITCH:
press this switch to feed wire.
Rotate the current setting knob
to adjust wire feed speed.
Use the scales on the
outer ring for setting
current for wire diameter
Ø1.2, Ø1.4, Ø1.6.
Use the scales on the
inner ring for setting
current for wire diameter
Ø0.8, Ø0.9, Ø1.0.
JOB No.
200
150
100
50
WELDING CURRENT
A
45
42
39
36
33
30
27
24
21
18
15
LOW
SYNERG. FINE ADJ.
V
INCHING
WELDING
VOLTAGE
HIGH
REMOTE
LOAD
500
450
400
350
300
250
200
150
100
INDIVIDUAL
1
2
3
4
5
7
8
10
9
6
Ø
1.2
/
1.4
/
1.6
Ø
0.8
/
0.9
/
1.0
250
C PVE400/500
Wminfo
