DWS-3160 Series Gigabit Ethernet Unified Switch CLI Reference Guide
417
Format
show loopdetect ports {<portlist>}
Parameters
ports
- Specifies the range of member ports that will display the LBD settings.
<portlist>
- Enter the list of port to be configured here.
If no port is specified, the configuration for all ports will be displayed.
Restrictions
None.
Example
To display the LBD settings on ports 1-9:
DWS-3160-24PC:admin#show loopdetect ports 1-9
Command: show loopdetect ports 1-9
Port Loopdetect State Loop VLAN
------ ------------------ ----------
1 Enabled None
2 Enabled None
3 Enabled None
4 Enabled None
5 Enabled None
6 Disabled None
7 Disabled None
8 Disabled None
9 Disabled None
CTRL+C
ESC
q
Quit
SPACE
n
Next Page
p
Previous Page
r
Refresh
40-7
config loopdetect trap
Description
This command is used to configure the trap modes for LBD.
Format
config loopdetect trap [none | loop_detected | loop_cleared | both]
Parameters
none
- There is no trap in the LBD function.
loop_detected
- Trap will only be sent when the loop condition is detected.
loop_cleared
- Trap will only be sent when the loop condition is cleared.
both
- Trap will either be sent when the loop condition is detected or cleared.
Содержание DWS-3160-24TC
