D-Link DWS-3160-24TC, Справочное руководство CLI

Страница: 105 / 983

DWS-3160 Series Gigabit Ethernet Unified Switch CLI Reference Guide
101
access_id - (Optional) Specifies the access ID.
<value 1-256> - Enter the access ID used here. This value must be between 1 and 256.
Restrictions
None.
Example
To display the flow metering configuration:
DWS-3160-24PC:admin#show flow_meter
Command: show flow_meter
Flow Meter Information
------------------------------------------------------------------------------
Profile ID:1 Aceess ID:1 Mode : trTCM / ColorBlind
CIR(Kbps):1000 CBS(Kbyte):2000 PIR(Kbps):2000 PBS(Kbyte):2000
Action:
Conform : Permit Counter: Enabled
Exceed : Permit Replace DSCP: 60 Counter: Enabled
Violate : Drop Counter: Disabled
------------------------------------------------------------------------------
Total Entries: 1
DWS-3160-24PC:admin#
6-7 config time_range
Description
This command is used to define a specific range of time to activate a function on the Switch by
specifying which time range in a day and which days in a week are covered in the time range.
NOTE: The specified time range is based on the SNTP time or the configured time. If
this time is not available, the time range will not be met.
Format
config time_range <range_name 32> [hours start_time <time hh:mm:ss> end_time <time
hh:mm:ss> weekdays <daylist> | delete]
Parameters
time_range - Specifies the name of the time range settings.
<range_name 32> - Enter the time range name used here. This name can be up to 32
characters long.
hours - Specifies the time of a day.
start_time - Specifies the starting time of a day.
<time hh:mm:ss> - Enter the starting time here. (24-hr time). For example, 19:00 means
7PM. 19 is also acceptable. The time specified in the start_time parameter must be
smaller than the time specified in the end_time parameter.