24
Gateway(config-net-PORT-
PORT)# no duplex
Configure port duplex to
half.
Note1 : Only copper ports can be
configured as half duplex.
Note2 : Auto-negotiation needs to be
disabled before configuring duplex
mode.
5. Enable flow control operation.
Command
Parameter Description
Gateway(config-net-PORT-
PORT)# flowcontrol
Enable flow control on port(s).
No command
Gateway(config-net-PORT-
PORT)# no flowcontrol
Disable flow control on port(s).
6. Operation mode selection.
Command
Parameter Description
Gateway(config-net-PORT-
PORT)# operation-mode nat
Enable NAT mode. When the Residential
Gateway is in this mode, all devices
connected to the Residential Gateway
from its LAN ports and WLAN are in the
private network.
Gateway(config-net-PORT-
PORT)# operation-mode bridge
Enable Bridge mode. When the
Residential Gateway is in this mode, all
devices connected to the Residential
Gateway from its LAN ports or WLAN are
in the public network.
No command
Gateway(config-net-PORT-
PORT)# no operation-mode
Return to NAT mode.
7. Shutdown Interface.
Command
Parameter Description
Gateway(config-net-PORT-
PORT)# shutdown
Disable interface.
No command
Gateway(config-net-PORT-
PORT)# no shutdown
Enable interface.
8. Set up port speed.
Command
Parameter
Description
Gateway(config-net-PORT-
PORT)# speed [1000|100|10]
[1000|100|10] Set port speed as 1000Mbps, 100Mbps or
10Mbps.