18
DHCP Vendor ID:
Enter the Vendor ID used for DHCP relay agent function.
Firmware Version:
Display the firmware version used in this device.
Current Boot Image:
The image that is currently using.
Configured Boot Image:
The image you want to use after reboot.
Image-1 Version:
Display the firmware version 1 (image-1) used in this device.
Image-2 Version:
Display the firmware version 2 (image-2) used in this device.
M/B Version:
Display the main board version.
Serial Number:
Display the serial number of this Gateway.
Up Time:
Display the up time since last restarting.
Local Time:
Display local time.
2. Display or verify currently-configured settings
Refer to the following sub-sections.
“Interface command”, “IP command”, “User command”, “VLAN
command
” sections, etc.
3. Display interface information or statistics
Refer to
“Show interface statistics command” and “Show sfp information command” sections.
4. Show default, running and startup configurations
Refer to
“show default-setting copmmand”, “show running-config command” and “show start-up-
config command
” sections.
2.5 Configuration Mode
When you enter
“configure” or “config” and press “Enter” in Privileged mode, you will be directed to
Global Configuration mode where you can set up advanced switching functions, such as QoS,
VLAN and storm control security globally. All commands entered will apply to running-configuration
and the device
’s operation. From this level, you can also enter different sub-configuration modes
to set up specific configurations for VLAN, QoS, security or interfaces.
Command
Description
advanced
Set up WAN MAC address mode
applications
Application global configuration commands.
exit
Exit the configuration mode.
help
Display a list of available commands in Configuration mode.
history
Show commands that have been used.
interface
Select a single interface or a range of interfaces.
ip
Set up the IPv4 address and enable DHCP mode snooping.
ipv6
Set up the IPv6 address and enable DHCPv6 mode snooping.
management
Set up console/telnet/web/SSH access control and timeout value.
no
Disable a command or set it back to its default setting.