23
2.5.6 Interface Command
Use
“interface” command to set up configurations of several discontinuous ports or a range of
ports.
1. Entering interface numbers.
Command
Parameter Description
Gateway(config)# interface lan
[port_list]
[port_list]
Enter several lan port numbers separated
by commas or a range of port numbers.
For example: 1,3 or 2-4
Gateway(config)# interface wan
[port_list]
[port_list]
Enter several wan port numbers
separated by commas or a range of port
numbers.
Gateway(config)# interface
wlan1
Enter WiFi 5G interface.
Gateway(config)# interface
wlan2
Enter WiFi 2.4G interface.
Note : You need to enter interface numbers first before issuing below 2-15 commands.
2. Enable port auto-negotiation.
Command
Parameter Description
Gateway(config-net-PORT-
PORT)# auto-negotiation
Set the selected interfaces
’ to auto-
negotiation. When auto-negotiation is
enabled, speed configuration will be
ignored.
No command
Gateway(config-net-PORT-
PORT)# no auto-negotiation
Set auto-negotiation setting to the default
setting.
3. Enable port auto-negotiation.
Command
Parameter
Description
Gateway(config-net-PORT-
PORT)# combo-mode
[copper|fiber]
[copper|fiber] Specify combo port on copper or fiber
port.
No command
Gateway(config-net-PORT-
PORT)# no combo-mode
Disable combo mode.
4. Set up port duplex mode.
Command
Parameter Description
Gateway(config-net-PORT-
PORT)# duplex [full]
[full]
Configure port duplex to
full.
No command