Cryomech LNP-40, Инструкция по установке, эксплуатации и текущему обслуживанию

Страница: 19 / 102

Safety
3-6
WARNING
One lead of the air compressor is grounded. Never bypass this ground or attach the
air compressor to an ungrounded circuit. A dangerous electrical hazard will develop.
Section 6.6.5 Check for correct rotation
CAUTION
Do not start the compressor before checking for proper oil level. Refer to the air
compressor instruction manual for proper oil charge.
Section 6.8 Air compressor to N
2
generator/filter bank panel connection
CAUTION
The compressed air filters are not designed to remove vaporous water. Vaporous
water will pass through the filters and damage the N
2
generator. This type of damage
is not covered under the warranty.
CAUTION
The maximum inlet air temperature to the N
2
generator /compressed air filter bank
panel is 125
°
F (52
°
C). Temperatures above 125
°
F (52
°
C) will damage the filter bank
components. This type of damage is not covered under the warranty.
CAUTION
The filter bank's ability to remove water from the incoming compressed air is
dependent on the temperature of the incoming air. As a rule, the incoming
compressed air temperature should be within 10
°
F (6
°
C) of the ambient temperature
for optimal operation of the compressed air filter bank. The maximum inlet air
temperature is 125
°
F (52
°
C).
Section 6.9 N
2
generator/filter bank panel to dewar connection
CAUTION
Do not allow the nitrogen flex line to come into contact with corrosives or any type of
commercial cleaning agent.
Leaks caused by exposure to corrosives or commercial
cleaning agents will not be covered under warranty.
CAUTION
Do not bend the nitrogen flex line to less than 5 inch (12 cm) radius or permanent
damage may occur.
This type of damage is not covered under the warranty