Cryomech LNP-40, Инструкция по установке, эксплуатации и текущему обслуживанию

Страница: 62 / 102

Installation
6-12
Figure 6-3: Rotation label on the air compressor motor
2) To check for correct rotation, briefly energize the dedicated circuit breaker to bump
start the air compressor and note the rotation of the electric motor’s pulley.
3) If the rotation is correct proceed to the next section.
4) Single Phase Air Compressors Only : If the rotation is incorrect, contact Cryomech.
5) Three Phase Air Compressors Only : If the rotation is incorrect, perform the following
steps to reverse the direction of the motor:
a) Make certain the dedicated circuit breaker is off to prevent electrical shock.
b) Examine the power cord and wire colors at the dedicated circuit breaker.
60 Hz Configuration 50 Hz configuration
Hot Black Hot Black (One - 1)
Hot Red Hot Black (Two - 2)
Hot White Hot Black (Three - 3)
Ground Green Ground (or Earth) Green w/ Yellow Stripe
Figure 6-4: Color codes for 60 Hz and 50 Hz models
c) If your system contains a 60 Hz power cord, switch the black and red wires. If
your system contains a 50 Hz power cord, swap any two black wires.
6) Briefly energize the dedicated circuit breaker to bump start the motor. The motor
should now turn in the correct direction.
6.7 Connection of refrigerated air dryer (option)
If the optional refrigerated air dryer is not supplied with the system, proceed to the next
section.
The outlet port of the air compressor is connected to the inlet port of the refrigerated air
dryer with the 50 ft (15 m) roll of 3/8” OD copper tubing supplied with the air compressor.
To aid in the cooling of the compressed air and condensing the moisture entrained in it,
Cryomech recommends using the entire length of copper tubing to connect the air
compressor to the dryer.
The outlet port of the dryer is connected to the inlet port of the filter bank panel with the
50 ft (15 m) roll of 3/8” OD copper tubing supplied with the dryer.