Covidien Puritan Bennett 560, Руководство пользователя

Страница: 17 / 150

Safety Information
User’s Manual 1-3
•
To minimise the risk of damage, you must use the ventilator’s Dual Bag to transport the
ventilator. See Table F-1,
List of Consumables and Accessories .
•
Regularly clean the ventilator’s Dual Bag according to manufacturer’s recommendations.
•
The ventilator should never be immersed in any liquid, and any liquid on the surface of the
device should be wiped away immediately.
•
To avoid damage to the ventilator, in particular the batteries or electrical components, fluids
must not be allowed to enter the device, particularly through the air inlet filter or the cooling
apertures located in the side, rear, and bottom panels of the ventilator.
•
To ensure correct and lasting operation of the device, ensure that the ventilator is installed and
operated in the environmental conditions recommended in Appendix
A, “Specifications.”
•
Do not leave power cables lying on the ground where they may pose a hazard.
•
Do not operate the ventilator in direct sunlight, near heat sources, outdoors, or near installations
where liquid may pose a risk without first providing adequate protection for the device.
•
Avoid using the ventilator, if possible, in dusty environments. Dusty environments may require
more vigilant monitoring, cleaning, and/or replacement of air intake and other filters.
•
Ensure that the ventilator’s immediate surroundings allow for the proper operational connection
of the device without folding, pinching, or damaging any of the required cables or tubes, and
that the connection of the patient circuit to the patient provides for a secure, comfortable fit.
•
Place the ventilator in a safe place when ventilating and according to the recommendations in
this manual.
•
Do not place the ventilator in a position where a child can reach it or in any position that might
cause it to fall on the patient or someone else.
•
To ensure correct and lasting operation of the ventilator, ensure that its air circulation holes
(main inlet or cooling) are never obstructed. Place the device in an area where air can freely
circulate around the ventilator and avoid installing it near floating fabrics, such as curtains.
•
If the ventilator has been transported or stored at a temperature that differs more than

20 °C
(

36 °F) from the temperature in which it will be operating, the ventilator should be allowed to
stabilise in its operating environment for at least two (2) hours prior to use.
•
If the ambient temperature where the device is operated is greater than 35 °C (95 °F), the flow
supplied at the device outlet may exceed 41 °C (106 °F). This may lead to undesirable side effects
for the patient. To avoid injury to the patient move the patient and the ventilator to a cooler
location. For more information, contact Covidien.
•
The default setting for altitude compensation is YES. Altitude compensation should always be
set to YES for accurate volume delivery calculations at all elevations.
•
To reduce the risk of a fire hazard, keep matches, lighted cigarettes, and all other sources of
ignition (such as flammable anesthetics and/or heaters) away from the ventilator and oxygen
hoses.
•
Regularly check the cleanliness of the air inlet filter located on the rear of the ventilator. If
necessary, replace the filter before the recommended replacement period is over (see chapter
8,
“Routine Maintenance” ). This is particularly important when the ventilator is installed on a
wheelchair, because environmental conditions may cause the filter to become dirty more rapidly.
•
Handle the ventilator with care during and after use, particularly when ambient temperatures
are high. Some ventilator surfaces may become hot, even if safety specifications are not
exceeded.
Warnings Regarding Electrical Power Supplies
•
Never connect your ventilator to an electrical outlet controlled by a wall switch because the
power may be inadvertently turned off.