Cooper Wheelock SAFEPATH 4 SP4-TZC, Инструкция по установке, испытаниям, эксплуатации и техническому обслуживанию

Страница: 38 / 51

38
Chapter 4 Paging Operation
4.1 Making A Zone Page (Zone Paging Enabled)
The following is the procedure for making a Zone Page using the SP4-TZC, with Zone Paging enabled.
Pick up the Telephone and connect to the SP4-TZC Zone Controller.
You will hear – Access Tone (500 milliseconds ON)
Audio Output – None
Key the 2 digit Zone Code for the desired zone location.
You will hear – Page Ready Tone (500 milliseconds ON)
Audio Output – Selected Zone or location will hear the alert tone if enabled.
NOTE
: If an invalid or unused 2 digit Zone Code is entered the operator will hear 3 short tones (100
milliseconds ON and 100 milliseconds OFF) followed by 1 long tone (500 milliseconds ON). The long
tone indicates that the paging system has been reset allowing you to enter another Zone Code. There is
no audio output when an invalid or unused Zone Code is entered.
Make the announcement.
Audio Output – Message will be broadcast to the select zone location.
NOTE:
When paging, Background Music will be muted in all zones.
At the conclusion of the page, simply hang-up the t elephone handset. The Background Music will
automatically be restored.
4.2 Making An All-Call Page (Zone Paging Disabled)
The following is the procedure for making an All-Call Page using the SP4-TZC, with Zone Paging disabled
using the SP4 Telzone Programmer software.
Pick up the Telephone and connect to the SP4-TZC Zone Controller.
You will hear – Page Ready Tone (500 milliseconds ON)
Audio Output – All zones or locations will hear the alert tone if enabled.
Make the announcement.
Audio Output – Message will be broadcast to all zones or locations.
NOTE:
When paging, Background Music will be muted in all zones.
At the conclusion of the page, simply hang-up the telephone handset. The Background Music will
automatically be restored.
STEP 1
STEP 2
STEP 3
STEP 4
STEP 1
STEP 3
STEP 2