Cooper Wheelock SAFEPATH 4 SP4-TZC, Инструкция по установке, испытаниям, эксплуатации и техническому обслуживанию

Страница: 31 / 51

31
Enter the name of the file and click the Save button. See Figure below.
Complete the task by clicking on the “
Send Configuration ” command button. This sends the new
configuration to the SP4-TZC. Notice that the “Zone Controller Successfully Programmed”
message appears on the computer screen, and that the USB CONFIG
LED indicator on the SP4-
TZC PC board turns ON . If an Error message appears, refer to Section 5.6 for details and
corrective action.
Click the
“OK” button on the “Zone Controller Successfully Programmed” message.
Test the Logical Zone Groups.
Shut down the SP4 Telzone Programmer 2 software on the host computer.
Disconnect the USB cable from the SP4-TZC Zone Controller and the host computer.
3.5.3 Warning Message for Duplicate Zones
The following Warning message will appear when a duplicate zone is selected in that Logical Zone Group.
Remember, Individual Zones and Fixed Zone Groups can be used in more than one Logical Zone Group.
Click the OK button. The location of the duplicate zone will be highlighted in the Logical Zone Group and
the zone number will default to zero.
STEP 11
STEP 12
STEP 13
STEP 14
STEP 10
STEP 15