Cooper safety Ceag AT-S+ C0, Монтаж и эксплуатация

Страница: 48 / 76

CEAG Notlichtsysteme GmbH 48
Operating
Assembly and Operating Instructions
Automatic Test System AT-S
+
with STAR
+
Technology
displaying
– Time and date (line 0)
– Operating mode (line 1)
– Fault information
(line 2)
– Device name (line 5)
Keypad
ESC key <ESC>
Menu key

ok key <ok>
and cursor keys
   
Memory card for saving and data
transmission of test log and parame-
ter settings
Control module
CU S
+
1 Test & status menu
1.1
Start functiontest
1.2
Sum failure info
1.3
Circuit state
1.4
Luminaire state
1.5
DLS/TLS/3PhW state
1.6
Relay state
Main menu
Main screen (Example)
1.
Test & status menu
2.
Block & reset alarms
3.
Basic settings
4.
DLS/TLS setup
5.
Circuit setup
6.
Luminaire setup
7.
Logbooksetup
Multi-Master Mode M3:
In Multi-Master Mode the following functions are
possible to activate:
– Start FT
– Substation-status (display)
– Block/release device
– Date/Time (set)
– Automatic FT (specify)

Previously, the substation needs to be found
in the menu «Main settings /Substation setup».

Before the execution of the command there
is a request in the Mulit Master Mode if this
system-no. or all systems of one group should
execute this command.
The M3 function can only be executed when all
control units are interconnected over the CG-S
bus and no CGVision is used.

If password protection is activated,
then only the main screen and the main
menu options “1 Test and Status Menu”
and “2 Block ,Reset” are accessible with-
out entering a password.
 The controller software automatically
returns to the main screen if no entry is
made within 180 seconds.

The graphic display backlighting goes
off if no entry is made within 180 sec-
onds.
Pressing any key switches the backlight-
ing on again.
 The contrast and brightness (back-
lighting of the graphic display) can be
adjusted in the main screen when the
<ok> key is pressed:

<ok> +

/

: contrast adjustment
 <ok> +  /  : brightness adjustment
These parameters can also be set with
menu option “3.10 Display Setting” in
menu “3 Basic Settings”.
Here the parameters can be numerically
set as percentages.