1. Click on "Configuration" and select a frame buffer in the top button bar of the page
displayed.
2. Specify the number of images that are to be recorded before an event.
3. Specify the number of images that are to be recorded following an event. The
maximum permissible total number of pre and post-event images is 16 or 32.
If the total number you entered exceeds 16 (384x288 pixels) or 32 (196x144
pixels), the number is automatically corrected to 16 or 32.
4. Specify the recording speed between the maximum speed (25 images per
second) and 1 image every 2 seconds.
5. Select the image size. The maximum number of images stored is 16 for large
images and 32 for the small images.
6. Save the data.
7. Start recording to the frame buffer by clicking the corresponding option in the
table in the lower part of the page. The black indicator to the right of the option will
change to red.
8. Repeat steps 1 to 7 for other frame buffers, if desired.
Stop recording to the frame buffer by clicking the corresponding option in the table in
the lower part of the page. The red indicator to the right of the option will change
back to black.
To send a frame buffer by e-mail or VdS 2465 notification, open the "Configuration /
Action / eMail or VdS2465” page, select the desired message and activate the
checkbox(es) next to the desired frame buffer(s). After they are sent, frame buffers
are automatically restarted. The images stored in the buffer are overwritten by a new
event.
A frame buffer that was activated but not sent will not be restarted. In this case, all
the pre and post event images will be displayed.
9.4.3 Output
(Time)
If an event occurs (at an input or under time-control) that is assigned an output, this
output is activated for the set time. For information on activating the outputs
manually, refer to Chapter 8.5.1.
1. Enter a name.
2. Enter the operating time for each of the two outputs (Output 1 and Output 2) in
the "Operating time" input field.
3. Save the data.
Manual
- 65 -