Configuring the Modem
In the "Analog Modem" menu you will find settings for a modem that supports the
extended Hayes command set.
The init strings for initializing the modem depend on the modem used. The init strings
for your device can be found in the operating instructions of your modem.
Make sure that you have chosen “Modem” under „Configuration/System/ISDN-
Modem/General”.
1. Enter the login name for identification for PPP.
2. Enter the PPP password.
3. If the values for your modem differ from the settings, please enter the correct
strings.
4. Save the data and reboot your device.
5. If you made a mistake, click "Default" to restore the settings.
After changes to this data, you have to reboot your Convision V6xx A.
Audio/Voice Transmission via ISDN
Apart from data transmission, the Convision V6xx A can also be addressed via a
telephone line. Audio data are transmitted via the B-channel of the ISDN. For this
reason, you have to connect the Convision V6xx A to the ISDN. The image data are
transmitted either via Ethernet or via the other B-channel. In this case, channel
bundling is no longer possible.
Connect a door intercom system to the audio connector (female) on the rear of the
device (refer to Figure 2: Rear view of the Convision V6xx A.)
1. For this purpose, remove approx. 10-13 mm of the insulation of the microphone
and loudspeaker cables.
2. Using a small screwdriver, press against the clamping device above the
receptacle and push the twisted cable into the receptacle.
3. After releasing the clamping device, it retains the cable. Check for tight seating by
easily pulling on the cable.
4. Enter the MSN of the Convision V6xx A in the "Audio" field.
5. Specify up to 5 telephone numbers that are to be permitted to call the Convision
V6xx A. Enter the first number in the first field. When entering the telephone
numbers, you can use "*" as a wildcard at the end of the number. This character
can stand in for one or multiple end numbers.
6. Save the data.
- 40 -
Convision V600 A Series
