TDMA CONTROL 602-702 Eng Nov.doc
61
After completing the electrical connections of the output unit, the input unit is
placed on top of the output unit and secured with three screws.
Screws
The electrical connections of the input unit can be installed (sensors, etc.).
7.1.2
Adjacent Mounting of Controller Units
Note: To fix the controller
An adjacent assembly is only possible with the separate cover (RE123). The
input module must be installed always to the right of the output module. This is
to prevent the SD Card slot from being blocked by the output unit. RE123
includes all the necessary cables etc to connect both sections together. After
connecting both sections the output unit should be fitted with the blank cover.
After removing the screw (1) the front cover can be tilted up from the front (2)
and removed (see picture opposite). When you reinsert the upper part make
sure the hinges slide into the slots provided, before lowering the front section
and refixing the screw.
The lower housing section is fixed to the wall by three screws. First drill and
screw two screws into the wall at 140 mm centres. Mount housing onto these
screws and then drill and insert the third screw through the lower hole and fix
to the wall.
2
1
140m
m
