Hardware Options Installation
3-3
Compaq Confidential – Need to Know Required
Writer:
Jennifer Hayward
Project:
Compaq ProLiant ML330 Generation 2 Server Setup and Installation Guide
Comments:
Part Number:
234833-001
File Name:
d-ch3 Hardware Options Installation.doc
Last Saved On:
5/23/01 3:48 PM
Removing the Front Bezel
To remove the front bezel:
CAUTION:
To prevent damage to equipment or loss of information, make sure
that the server is powered down, all cables are disconnected from the back of
the server, and the power cord is disconnected from the grounded (earthed)
AC outlet before removing the front bezel.
1.
Follow the steps in “Powering Down the Server” earlier in this chapter.
2.
Pull up on the latch at the bottom of the front bezel, applying enough
pressure to release the latch from the chassis
.
3.
Swing the bezel upward, and then slide it out and away from the
chassis
. You may need to exert a small amount of force to release the
bezel from the chassis.
2
1
Figure 3-1. Removing the front bezel
To replace the front bezel, reverse steps 2 and 3.
NOTE:
When replacing the front bezel, make sure that the top hinge points are properly
placed in the chassis before rotating the front bezel into its original position.
