17
1
2
20 cm
1
2
The antenna must be correctly connected and its connector
must be fully tightened.
Antenna presence can be detected only using the antenna
supplied. In all other cases antenna presence detection
must be excluded from the GSM dialler options.
ANTENNA POSITIONING WITH HOUSING ART. BOXMETAL
ANTENNA POSITIONING WITH HOUSING ART.
BOXPLASTIC
IMPORTANT: place the antenna outside the
housing using the "antenna outlet" provided
Do not place the antenna on metal surfaces
IMPORTANT: place the antenna in the special slot under
the battery (as shown in the figure).
CAUTION:
If the position of the control panel does not allow the reception
of an adequate GSM signal to ensure a good connection, it is
possible to fit an external antenna:
- moving the antenna and using an extension cable,
- using an external antenna (Art. 2G50000296).
For this purpose, there is a pre-marked section to allow
easy exit of the antenna cable.
OK !
NO !
FITTING THE SIM CARD
√
The SIM card must be enabled, and if it is a pay-as-you-go
type, it must have sufficient credit on it to be able to make
phone calls or send messages. It is not essential to unlock it,
because the control panel is capable of managing the PIN to
unlock the SIM card.
1.
Gently force the top of the SIM connector towards the centre
of the control panel card (downwards if the control panel is
already mounted on the wall).
2.
Once you have overcome the resistance, turn it over on its
hinges.
3.
Insert the SIM card in the mobile part in such a way that you
can see the gold-coloured contacts of the SIM and that the
bevelled corner is on the left.
4.
Repeat the sequence in reverse to release the SIM card
from its seat.
First check that all power is OFF.
Place the antenna at least 20 cm away from the GSM
module.
Do not place the antenna on metal surfaces
