Notes:
Page 80 of 107
SmartLF Gx Service Manual
6.11 Setting up the Paper Hold down Roller.
1.
When setting up the paper hold down roller against the glass,
it must be set up so that the soft roller is just touching the
glass. It must not be above the glass so light can be seen
through the scanner, or so far down that the roller is actually
flattened against the glass. This set up must be carried out
with the raising lid set down to its lowest point prior to
adjustment being made.
2.
If the roller looks like it needs lowering, turn the screws on the
roller height bearing at the end which is highest clockwise to
lower the bearing which will lower the roller when the lid is
closed. Check the height, and adjust the roller again in
necessary.
Roller sitting correctly Rollers not sitting correctly, needs
adjusting.
