Notes:
Page 70 of 107
SmartLF Gx Service Manual
5.
Above image shows an in-focus camera where the lines are
even and at their peak distance apart. The insert shows an out
of focus camera where the lines are too close together. If the
lines are low, turn the adjustment screw until the distance
between the lines starts to get bigger, if turning the screw
narrows the lines, turn the screw the opposite direction until it
starts to raise. Turn the screw until the height of the focus line
is at it's peek, if the lines start to narrow again, turn the screw
the opposite way to bring them back up.
6.
Tighten the locking screws back up.
7.
Carry out the alignment process as described in the chapter
6.8.2 "Aligning The Gx Camera" page 58.
8.
Normalise and autostitch the scanner as in chapters 8.3 & 8.4
"Normalisation" and "Autostitch" pages 95 & 97.
Out of focus
In focus
