Notes:
Page 67 of 107
SmartLF Gx Service Manual
Manipulate the screws to position the camera board so that the
image on the PC is correct. This means the screws can be turned in
either direction to get it correct. There is no specific rule to this, it is
down to moving the camera until the image appears as shown with
the lines fully down, and may be a time consuming process. Each
camera must be aligned in this way.
11. After achieving a good alignment, tighten the screws back up.
This has to be done carefully, tightening in small amounts on
each screw. If the alignment looks to move out, then stop
tightening the screws, re-adjust the alignment as above and
then continue tightening the locking screws. Tighten the
screws in opposite corners, as shown in the diagram below,
starting with the top Left Hand screw. Do not over tighten.
NOTE: There are 2 types of camera castings used in the Gx
scanners. One style has a 5 camera casting, which houses all the
cameras on one long casting, this is fitted to the all newer scanners,
and the older scanners have 5 individual casting housing a camera
each. But styles are aligned in exactly the same way using the
same method and target and software.
Tighten the screws in an opposite corner pattern starting
with top Left Hand corner, moving to bottom Right Hand
corner etc.
