Collomix XM 2-650, Руководство по эксплуатации

Страница: 18 / 23

Collomix GmbH Forced-action mixer
85080 Gaimersheim / Germany Collomatic XM
Ref.no.: 39017 Rev. US02-2013 Page 18
12. Descrip琀椀on of the safety equipment
The power switch is also an EMERGENCY STOP switch at the same 琀椀me and has an
undervoltage release. Switch the switch to “0”. This switches the machine completely o昀昀.
The undervoltage release is for ensuring that the switch automa琀椀cally jumps to “0” in the
event of undervoltage. The man purpose of this is to prevent the machine from being started
up again uninten琀椀onally.
This can be the case in the following situa琀椀ons:
• In the event of a power failure
• If the cable is pulled from the plug
• In the event of a power failure in the mains power supply
• If the drive unit overheats Allow the drive unit to cool down and then try to restart.
Reduce the amount of mixing material if necessary.
The safety devices previously referred to have been integrated in the machine for your
personal safety and the safety of others. Make sure that these are in full working order at all
琀椀mes. Never start the machine if any safety devices are defec琀椀ve. Anyone who deliberately
removes any safety devices or renders them inopera琀椀ve is liable to prosecu琀椀on. Such an
ac琀椀on would cause incalculable danger for the user. At the same 琀椀me this would also render
the warranty for the machine null and void.
12.1 Guard cage
The gear unit and the mixing tools are protected from direct access by a guard cage which
is 昀椀xed 昀椀rmly to the frame of the machine. The mixing tools start to run before the machine
is fully closed. The remaining gap between the swivel arm and the top edge of the tub is
covered by the guard cage. In addi琀椀on, we should also advise that it is not permi琀琀ed to
reach into the area between the guard cage and the tub while the machine is being closed
or opened. The guard cage has an opening on the top, covered by a mesh guard, to enable
you to see into the tub.
12.2 Safety switch
The machine is switched to enable status by the control pin, via a limit switch, as soon as a
suitable tub is in the machine. The machine will not start without a tub in place. Make sure
that the control pin moves freely at all 琀椀mes and make sure that it never becomes soiled.
Bridging the switch or pressing it by hand without a tub in the machine is not permi琀琀ed
12.3 Power switch/EMERGENCY STOP switch with undervolt-
age release