Collomix XM 2-650, Руководство по эксплуатации

Страница: 13 / 23

Forced-action mixer Collomix GmbH
Collomatic XM Gaimersheim / Germany
Page 13 Rev. US02-2013 Ref.no.: 39017
7.0 Bucket Dolly (accessory)
The trolley (accessory) is designed for loading and unloading the mixing tub to and from
the machine. At the same 琀椀me the locking device on the trolley can be used to enable thin-
bodied material to be poured out wherever it is required.
The trolley is supplied for 17 gals. tubs as standard.
7.2 Handling of the buckt dolly
• Take hold of the trolley by both handles.
• Move the two tub mounts under the tub and hook them both into the two recessed
handles on the tub.
• Press against the axle with one leg. Make sure that the tub is correctly in place.
• Tilt the trolley towards you un琀椀l you have the tub in balance.
• If you are processing thin-bodied materials you can pour them by applying the locking
device:
• Pick up the tub as described above. Then set the trolley down lengthwise on the 昀氀oor.
The tub swings free.
• First set the tub stop to ver琀椀cal. The hook on the tub holder extends over the edge of
the tub and holds it.
• Then turn the tub holder so that its handle is posi琀椀oned ver琀椀cally upwards. The tub is
now locked.
• Now li昀琀 the trolley again slowly. As soon as you have reached a certain angle the
material will 昀氀ow out of the tub.
• Once you have 昀椀nished pouring, set the trolley down again and release the tub holder
and tub stop.
Using the pouring device
7.1 Assembly of bucket dolly for 17 gal. tub
See extra manual for the bucket dolly.
First remove the two cable binders from the moving parts.
Fit the two handle ends and fasten each of them with a screw.
Tighten the two arms with the thumb screws.