Claydon HYBRID M3, Руководство оператора

Страница: 43 / 66

43
H
IN FIELD OPERATION
OPERATORS MANUAL - HYBRID - M3, M4, M4R, M4.8 & M6
SETTING THE SEED SIZE SOWING RATE
1. Slider position decal location
Red lever (on shaft) out ( 2 ) Maximum
opening 25
Red lever (on shaft) in ( 3 ) Maximum
opening 105
To select small Seed or Large seed settings:
With the metering unit empty wind in the slider to the fully closed position. Carefully rotate the red lever to
slot into the cut out notch on the shaft i.e.
out
for small seeds and
in
for large seeds as shown below. Then
carefully wind the slider back out to the desired rate required using the chart located on the side of the drill
chassis as a guide.
0 10 20 30 40 50 60 70
Fine Seed
Normal Seed
80 90 100 110
Small seed setting Large seed setting
Set the seed rate required on the ISOCAN unit in the tractor. Now set the metering unit to the corresponding
setting using the table located on the side of the machine. Adjust the metering unit to the correct position
using the decal as a guide.
2. 3.
!
DO NOT REDUCE THE METERING SETTING WITH THE METERING
UNIT FULL THIS WILL RESULT IN DAMAGE TO THE METERING UNIT.
!