Citel EXTender IP6000, Быстрое руководство по установке

Страница: 47 / 48

Figure 30: RVP_Direct Call_Suspend Settings
4. Press the
È
and
Æ
key to the Timeout parameter. This parameter causes the units to go into Call
Suspend mode when no activity occurs for the set Timeout value. Set the value between 15 and 240
minutes.
5. (RVP_Over_IP Only) Press the
È
and
Æ
key to the Minimum Connect Time parameter. Enter a
value, in minutes (0 –240) that the EXTender will be connected to the Gateway before falling into Call
Suspend.
6. Press the
È
and
Æ
key to the Remote Only Wakeup parameter. If you set this parameter to Yes, you
enable wakeup from Call Suspend on activity at the Branch site only (for example, when a telephone
set goes off-hook or a key is pressed). If you set this parameter to No (disabled), incoming calls can
also cause wakeup from Call Suspend.
7. Press the
È
and
Æ
key to the Remote Login Timeout parameter. Enter a value, in minutes (15 –
240) that the EXTender will be idle, before Call Suspend is enabled.
8. Press the
Å
key to accept changes and go back to the Configuration Menu.
Procedure for Norstar (Gateway Configuration)
There is a problem when the gateway reboots because the remote unit has no way of knowing that the
gateway has lost synchronization. Until the two units re-synchronize, all incoming calls will be ignored. To
resolve this issue, the gateway unit will attempt to re-connect to the remote unit a configurable number of
times, this is called
Num Dials on Reboot (assumes the network link and the remote unit are still
functioning).
Gateway
Æ
Configuration
Æ
Connect
Æ
RVP_Direct
Æ
Call Suspend
Figure 31: Num Dials on Reboot
EXTender™ IP6000 Quick Installation Guide 47