Citel EXTender IP6000, Быстрое руководство по установке

Страница: 24 / 48

Synchronous-Serial (RVP_Direct)
This section of the manual provides the necessary information to configure the EXTender for connection
to a synchronous-serial device. The units are programmed at the factory with “default” settings providing
basic parameters to accommodate many network environments.
Public
Branch Office
Punch Block
EXTender IP6000
Punch Block
PBX
Corporate Office
PBXgateway
Router
DSU/CSU
DSU/CSU
Router
Figure 8: RVP_Direct Typical Installation
Prerequisites for Configuration
•
The Gateway (at the corporate site) and the EXTender (at the branch office) must be installed
properly and the network link between both devices must be operational.
•
The network administrator must assign an IP address for both units if you plan to configure and test
them over a LAN or WAN.
Table 6: RVP_Direct Configuration Steps
You must...... To...... Default Setting
Set Connect Parameters 1. Select network type RVP_Direct
2. Identify the Primary Interface WAN_1
3. Set Utilization. 100
Enable/Disable WAN ports Enable WAN ports to connect to network
device. WAN 1 - Enabled
Set the Sync Rate of the WAN
port 512,000 kbps
Match the data rate (sync rate) of the
network device
Set the mode (interface type) of
the WAN port. (v.35, RS-232,
RS-530) Match the interface type of the network
device. V.35
EXTender™ IP6000 Quick Installation Guide 24