Citel EXTender IP6000, Быстрое руководство по установке

Страница: 27 / 48

IP Network (RVP_Over_IP)
This section of the manual provides the necessary information to configure the EXTender for connection
within an IP network.
Note: The units are programmed at the factory with RVP_Direct “default” settings. The Type parameter
must be set to RVP_Over_IP
.
IP Network
Branch Office
Punch Block
EXTender IP6000
Punch Block
PBX
Corporate Office
PBXgateway
Ethernet
RJ21
Ethernet
Figure 10: RVP_IP Typical Installation
Prerequisites for Configuration
•
Both EXTender and Gateway must be installed properly and the network link between both devices
must be operational.
•
The network administrator must assign IP address information for both Gateway and Remote units.
•
The network administrator must provide the remote users with User ID’s and Connect Passwords (if
assigned).
TCP/UDP Requirements
Ensure that the correct TCP/UDP ports have been opened to allow the EXTender to connect to the
Gateway through your company firewall. The following TCP/UDP port requirements must be met:
The EXTender 6000 uses even numbered ports 12,288 to 12,544. The port numbers start at 12,288 and
increment by 2 to the total number of ports used. For example, if you have an 8 port EXTender 6000 with
3 telephones connected, ensure that ports 12,288, 12,290, and 12,292 are opened.
The Gateway unit uses TCP/UDP port 2698.
Basic Configuration
Table 8: RVP_IP Basic Configuration Steps
You must … to… Default Settings
Set Connect Parameters. Type: RVP_Over_IP RVP_Direct
IP Destination: Enter the IP address of the
Gateway.
-
10000000 EXTender Port Bandwidth
100 Set the Utilization:
Disable WAN ports Disable WAN ports that are unnecessary for
RVP_IP. WAN 1 – Enabled
WAN 2 -Disabled
Allow the Gateway to communicate over the IP
network. - Set IP parameters;
9
IP Address
9
Subnet
9
Default Router
EXTender™ IP6000 Quick Installation Guide 27