Citel EXTender IP6000, Быстрое руководство по установке

Страница: 25 / 48

Asynchronous-Serial (RVP_Direct)
This section of the manual provides the necessary information to configure the EXTender for connection
to an asynchronous-serial device. The units are programmed at the factory with “default” settings
providing basic parameters to accommodate many network environments.
ISDN
Branch Office
Punch Block
EXTender IP6000
Punch Block
PBX
Corporate Office
PBXgateway
ISDN TA
ISDN TA
Figure 9: RVP_Direct Async Connections
Prerequisites for Configuration
•
Both the Gateway and Remote units must be installed properly and the network link between both
devices must be operational.
•
The network administrator must assign IP address information for both Gateway and Remote units.
•
The network administrator must provide the remote users with User ID’s and Connect Passwords (if
assigned).
Table 7: Basic Configuration
You must…. To…. Default
Setting
Set the Primary Dial
Numbers (DNs) Identify the first and second ISDN B-channels at the Gateway
unit. -
The “Primary Dial Nums 1” is the Directory Number (DN) assigned to
the first B-channel of the ISDN line connected at the Gateway unit.
The “Primary Dial Nums 2” is the Directory Number (DN) assigned to
the second B-channel of the ISDN line connected at the Gateway
unit. Dial these telephone numbers to connect to the Gateway.
Set the mode
(interface type) of the
WAN port. Match the interface type of the network device. Set to Async-
RS-232-Dial
.
V.35
EXTender™ IP6000 Quick Installation Guide 25