Citel EXTender IP6000, Быстрое руководство по установке

Страница: 18 / 48

Connections
The following figures show the required EXTender connections, A through C.
Note: Connection “F” is for synchronous or asynchronous-serial only; “H” is for connection to an analog
line; and connection “G” is for VOIP.
Connected Ports (solid green)
A
LNK
CLN
3 1 2 8 9 10 11 12 7 6 5 4
Port Status
PWR 1 3 2
Console
WAN
Reset
Figure 3: Front of EXTender 6000
B C D E F G H
LNK
CLN
ANALOG LAN
0
TELEPHONY INTERFACE
WAN 1
WAN 2
100-240 V ~ 0.8A 50-60 HZ
LNK ACT
LAN
Figure 4: Back of EXTender 6000
Table 3: EXTender Connections
Letter Label Cable Type Description
A Console DB-9 Connect to a PC COM port
Note: Set the COM port as follows: Baud rate: 9600,
Databits: 8, Parity: none, Stopbits: 1, Software flow
control: Xon/Xoff
.
B
Fan - Cools unit.
C
Power - Connect to a 120 VAC outlet
D
Power Switch - Turns unit on and off.
E
Telephony Interface RJ-21 Wire to a punchdown block and then to the PBX. (See
Pin Out Assignments on page 19)
F WAN1 DB-25, serial.
straight-through Connects the EXTender to a synchronous or
asynchronous- serial device (CSU/DSU or other
network device).
WAN2
Note: Use an RS-530 type cable or DB-25 to M34 cable
should for high-speed links to V.35 equipment.
LAN RJ-45 Ethernet G Connects the EXTender to the LAN for use in VOIP
applications.
H Analog RJ-11 Connects to an analog line for local dialing.
Note: This port does not provide PBX functionality or
features.
EXTender™ IP6000 Quick Installation Guide 18