Citel EXTender IP6000, Быстрое руководство по установке

Страница: 20 / 48

VT-100 Setup
1. Make sure the EXTender is connected as shown on page 17.
2. You must use communications software — for example, HyperTerminal — to configure and test the
EXTender. Attach one end of the RS-232 cable to your PC COM port and the other end to the DB-9
Console port connector on the front of the EXTender.
3. Set up HyperTerminal as follows:
A
Access: Start button > Programs > Accessories >Communications > HyperTerminal folder >
HyperTerminal icon.
B
When prompted for a name, type gateway and click OK .
C
(Determine what port [ n] you will connect to on your pxc. At the Telephone Number dialog, select
Connect using = Direct to COMn (ignore other settings) and click OK .
D
At the CO Mn
1
Properties dialog, set the parameters to 9600, 8 , none , 1 and Xon/Xoff and click
OK .
E
When the HyperTerminal window appears, it is blank; that is, there is no logon prompt.
F
Click on File, then Properties. Select Settings tab and go to Emulation window. Select VT100
and click OK.
1
n is the number of the COM port on the PC .
4. Go
to Power-Up sequence on the next page.
EXTender™ IP6000 Quick Installation Guide 20