C H A P T E R
7-1
Cisco 1120 Connected Grid Router Hardware Installation Guide
OL-26438-02
7
About Connected Grid Modules
This chapter describes how to find installation information for the Cisco Connected Grid modules that
support the Cisco 1120 Connected Grid Router, and contains the following sections:
•
Installing or Replacing Modules, page 7-1
•
Where to Find Additional Module Information, page 7-4
Installing or Replacing Modules
The router supports up to two Cisco Connected Grid modules to enable network connections from the
router to field devices, such as smart meters, and from the router to the utility or data management center.
Depending on the configuration, your router could arrive in the shipping container with all required
modules already installed. However, you might need to install a module when you:
•
Add modules to your current installation.
•
Must replace a faulty module.
Installing Modules in the Router
This section provides general instructions for installing modules in the router. For information specific
to a particular module, refer to the module installation and configuration guides on Cisco.com, at:
www.cisco.com/go/cg-modules.
This section contains the following topics:
•
Preparing to Install Modules, page 7-2
•
Module Installation Locations, page 7-2
•
Install Modules, page 7-3
•
Remove Modules, page 7-4