4-4
Cisco 1120 Connected Grid Router Hardware Installation Guide
OL-26438-02
Chapter 4 Mounting the Router
Mounting Instructions
Mounting Instructions
This section includes all the steps required to mount the router on a wall or DIN rail. There are two main
procedures for mounting the router:
1.
Attach the Mounting Bracket to the Router, page 4-4
2.
Mount the Router on a DIN Rail, page 4-6
In some environments, you might want to mount the router on a wall instead of DIN rail. The wall
mounting procedure is described in
Mount the Router on a Wall, page 4-7
.
Attach the Mounting Bracket to the Router
Before you begin, disconnect the router from power and any network connections.
Step 1
Place the router on a stable surface, with the base of the router facing up and the module panel at the top,
as shown in
Figure 4-2
.
Step 2
Use the #2 Phillips screwdriver to remove the four large screws (Item 1,
Figure 4-2
) from the chassis
base. Keep the screws. You will replace them at the end of this procedure to mount the bracket on the
chassis.
Step 3
Remove only the screws indicated in
Figure 4-2
. Do not remove the smaller screws, which secure the
router bottom panel to the chassis.
Figure 4-2
Remove the Four Large Screws (1) from the Router Base
302212
Module Panel
Cable Panel
1
1
