![background image](http://html.mh-extra.com/html/cisco/firepower-1120/firepower-1120_hardware-installation-manual_63641046.webp)
4-6
Cisco 1120 Connected Grid Router Hardware Installation Guide
OL-26438-02
Chapter 4 Mounting the Router
Mounting Instructions
Figure 4-4
Replace and Tighten Screws to Secure Bracket to Router
Mount the Router on a DIN Rail
The steps in this section assume that your substation or utility box already has a DIN rail installed and
ready to support equipment. If your environment does not use DIN rails, you can
Mount the Router on
a Wall, page 4-7
.
To mount the router on a DIN rail:
Step 1
Tilt the chassis-bracket assembly about 10 to 30 degrees and the bracket handle facing down. Do not
mount the router with the bracket handle facing up.
Step 2
Place the
top lip of the bracket
(Item 2 in
Figure 4-5
) over the top of the
DIN rail
(Item 3 in
Figure 4-5
).
Step 3
Firmly pull the
bracket handle
(Item 1 in
Figure 4-5
) down and rotate the unit until it is parallel to the
wall or DIN rail.
Caution
Use caution when pulling the bracket handle: The handle is spring-loaded and will snap shut when
released quickly.
Step 4
Slowly release the bracket handle so that the bottom lip of bracket is secured over the top of the DIN rail.
302212
1