Cisco Cisco Unified Queue Manager, Руководство по обслуживанию и устранению неисправностей

Страница: 92 / 148

8-28
Cisco Customer Response Solutions Servicing and Troubleshooting Guide, Release 5.0(1)
Chapter 8 Troubleshooting Tips
CRS Editor Problems
Syslog or SNMP trap notification of database purging activities is not sent
Symptom The CRS system does not send Syslog notification or SNMP trap notification of purging
activities.
Error Message
None.
Possible Cause
The Cisco CRS Alarm Service is not running, Syslog is not configured, or SNMP service
is not configured.
Complete the following steps:
Step 1 Make sure that the Cisco CRS Alarm Service is running.
Step 2
Make sure that Syslog is properly configured.
Step 3 Make sure that SNMP service is properly configured on the CRS server.
CRS Editor Problems
This section contains the following troubleshooting tips on CRS Editor problems:
•
Change a string variable to an integer, page 8-28
• Accept step error during active debug, page 8-28
•
Error occurs with Reactive Debugging Tool, page 8-29
Change a string variable to an integer
Symptom You want to change a string variable to an integer.
Error Message
None.
Possible Cause
None.
Recommended Action
Use the Set step, which supports the conversion of a string to any numerical type.
Accept step error during active debug
Symptom While debugging an application, the following message appears, where n is the task ID:
Error Message Task:
n
Accept Step: Trigger is not a Contact Application trigger.
Possible Cause
The debugger encountered the Accept step in the application but there was no call to
answer.
Recommended Action
Debug the application as a Reactive Application and make the call before the
Reactive Application times out.