Cisco 5505 - ASA Firewall Edition Bundle, Руководство по настройке CLI

Страница: 1420 / 2164

1-14
Cisco ASA Series CLI Configuration Guide
Chapter 1 Configuring the Botnet Traffic Filter
Configuring the Botnet Traffic Filter
Step 3
(Optional)
dynamic-filter drop blacklist [ interface
name ] [ action-classify-list
subset_access_list ] [ threat-level { eq
level | range min max }]
Example:
hostname(config)# dynamic-filter drop
blacklist interface outside
action-classify-list
dynamic-filter_acl_subset threat-level
range moderate very-high
Automatically drops malware traffic. To manually drop traffic,
see the
“Blocking Botnet Traffic Manually” section on page 1-15 .
Be sure to first configure a dynamic-filter enable command to
monitor any traffic you also want to drop.
You can set an interface policy using the interface keyword, or a
global policy (where you do not specify the interface keyword).
Any interface-specific commands take precedence over the global
command. You can enter this command multiple times for each
interface and global policy.
The action-classify-list keyword limits the traffic dropped to a
subset of monitored traffic. The dropped traffic must always be
equal to or a subset of the monitored traffic. For example, if you
specify an access list for the
dynamic-filter enable command,
and you specify the action-classify-list for this command, then it
must be a subset of the dynamic-filter enable access list.
Make sure you do not specify overlapping traffic in multiple
commands for a given interface/global policy. Because you
cannot control the exact order that commands are matched,
overlapping traffic means you do not know which command will
be matched. For example, do not specify both a command that
matches all traffic (without the
action-classify-list keyword) as
well as a command with the action-classify-list keyword for a
given interface. In this case, the traffic might never match the
command with the
action-classify-list keyword. Similarly, if you
specify multiple commands with the action-classify-list
keyword, make sure each access list is unique, and that the
networks do not overlap.
You can additionally limit the traffic dropped by setting the threat
level. If you do not explicitly set a threat level, the level used is
threat-level range moderate very-high .
Note
We highly recommend using the default setting unless you
have strong reasons for changing the setting.
The level and min and max options are:
•
very-low
•
low
•
moderate
•
high
•
very-high
Note
Static blacklist entries are always designated with a Very
High threat level.
Command Purpose