![background image](http://html.mh-extra.com/html/cisco/2800-series/2800-series_manual_64812031.webp)
15
Basic Software Configuration Using the Setup Command Facility
OL-5992-01
Examples of Using the Setup Command Facility to Configure Interface Parameters
Note
If your router does not have a configured LAN interface, you must use a numbered IP address.
IP address for this interface:
192.0.0.1
Enter the subnet mask [255.0.0.0]:
Point-to-Point Protocol Encapsulation
The following is a sample configuration for point-to-point protocol (PPP) encapsulation:
Would you like to enable multilink PPP [yes]:
Enter a username for CHAP authentication [Router]:remote_router
Enter a password for CHAP authentication: secret
Note
The password, which is used by the Challenge Handshake Authentication Protocol (CHAP)
authentication process, is case sensitive and must exactly match the password for the remote router.
Frame Relay Encapsulation
The following is a sample configuration for Frame Relay encapsulation:
The following lmi-types are available to be set,
when connected to a frame relay switch
[0] none
[1] ansi
[2] cisco
[3] q933a
Enter lmi-type [2]:
Note
The setup command facility prompts you for the DLCI number only if you specify
none
for the LMI
type. If you accept the default or specify another LMI type, the DLCI number is provided by the
specified protocol.
Enter the DLCI number for this interface [16]:
Do you want to map a remote machine’s IP address to dlci? [yes]:
IP address for the remote interface:
2.0.0.2
Do you want to map a remote machine’s IPX address to dlci? [yes]:
IPX address for the remote interface:
40.1234.5678
Serial interface needs clock rate to be set in dce mode.
The following clock rates are supported on the serial interface.
0
1200, 2400, 4800, 9600, 19200, 38400
56000, 64000, 72000, 125000, 148000, 500000
800000, 1000000, 1300000, 2000000, 4000000, 8000000
choose speed from above: [2000000]:
1200
Configure IP on this interface? [yes]:
IP address for this interface:
192.0.0.1
Subnet mask for this interface [255.0.0.0]:
Class A network is 2.0.0.0, 8 subnet bits; mask is /8
Note
If IPX is configured on the router, the setup command facility prompts you for the IPX map:
Do you want to map a remote machine's IPX address to dlci? [yes]:
Содержание 2800 Series
Страница 64: ...22 Basic Software Configuration Using the Cisco IOS Command Line Interface OL 5593 01 Additional References ...
Страница 125: ...Easy VPN Configuration Example Configure 5 OL 6340 01 Private IP address pool 192 168 3 0 24 ...
Страница 138: ...Easy VPN Configuration Example Related Information 18 OL 6340 01 ...
Страница 140: ...Easy VPN Configuration Example Related Information 20 OL 6340 01 ...