12
Basic Software Configuration Using the Setup Command Facility
OL-5992-01
Examples of Using the Setup Command Facility to Configure Interface Parameters
Frame Relay Encapsulation
The following is a sample configuration for Frame Relay encapsulation:
The following lmi-types are available to be set,when connected to a frame relay switch:
[0] none
[1] ansi
[2] cisco
[3] q933a
Enter lmi-type [2]:
Note
The setup command facility prompts you for the data-link connection identifier (DLCI) number only if
you specify
none
for the Link Management Interface (LMI) type. If you accept the default or specify
another LMI type, the DLCI number is provided by the specified protocol.
Enter the DLCI number for this interface [16]:
Do you want to map a remote machine’s IP address to dlci? [yes]:
IP address for the remote interface:
2.0.0.2
Do you want to map a remote machine’s IPX address to dlci? [yes]:
IPX address for the remote interface:
40.1234.5678
Serial interface needs clock rate to be set in dce mode.
The following clock rates are supported on the serial interface.
0
1200, 2400, 4800, 9600, 19200, 38400
56000, 64000, 72000, 125000, 148000, 500000
800000, 1000000, 1300000, 2000000, 4000000, 8000000
choose speed from above: [2000000]:
1200
Configure IP on this interface? [yes]:
IP address for this interface:
192.0.0.1
Subnet mask for this interface [255.0.0.0]:
Class A network is 2.0.0.0, 8 subnet bits; mask is /8
If Internetwork Packet Exchange (IPX) is configured on the router, the setup command facility prompts
you for the IPX map:
Do you want to map a remote machine's IPX address to dlci? [yes]:
IPX address for the remote interface:
40.0060.34c6.90ed
LAPB Encapsulation
The following is an example of configuration for LAPB encapsulation, selecting either DCE or DTE
mode, with DTE as the default:
lapb circuit can be either in dce/dte mode.
Choose either from (dce/dte) [dte]:
X.25 Encapsulation
The following is a sample configuration for X.25 encapsulation:
x25 circuit can be either in dce/dte mode.
Choose from either dce/dte [dte]:
Enter local x25 address:
1234
We will need to map the remote x.25 station’s x25 address
to the remote station’s IP/IPX address
Enter remote x25 address:
4321
Содержание 2800 Series
Страница 64: ...22 Basic Software Configuration Using the Cisco IOS Command Line Interface OL 5593 01 Additional References ...
Страница 125: ...Easy VPN Configuration Example Configure 5 OL 6340 01 Private IP address pool 192 168 3 0 24 ...
Страница 138: ...Easy VPN Configuration Example Related Information 18 OL 6340 01 ...
Страница 140: ...Easy VPN Configuration Example Related Information 20 OL 6340 01 ...