![background image](http://html.mh-extra.com/html/cisco/2800-series/2800-series_manual_64812013.webp)
7
Overview
OL-6154-01
Performing Initial Configuration
Initial Configuration Using the Command-Line Interface
This section describes briefly how to display a command-line interface (CLI) prompt for configuration
using the CLI.
You can use the CLI if the following messages appear at the end of the startup sequence:
--- System Configuration Dialog ---
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Would you like to enter the initial configuration dialog? [yes/no]:
If these messages do not appear, SDM and a default configuration file were installed on the router at the
factory. To use SDM to configure the router, see the
“Initial Configuration Using the Cisco Router and
Security Device Manager” section on page 3
.
Note
Be sure to save your configuration changes occasionally so that they are not lost during resets, power
cycles, or power outages. Use the
copy running-config startup-config
command at the privileged
EXEC mode prompt (
Router#
) to save the configuration to NVRAM.
Step 1
To proceed with manual configuration using the CLI, enter
no
when the power-up messages end:
Would you like to enter the initial configuration dialog? [yes/no]:
no
Step 2
Press
Return
to terminate autoinstall and continue with manual configuration:
Would you like to terminate autoinstall? [yes]
Return
Several messages appear, ending with a line similar to the following:
Copyright (c) 1986-2004 by cisco Systems, Inc.
Compiled <
date
> <
time
> by <
person
>
Step 3
Press
Return
to display the
Router>
prompt:
...
flashfs[4]: Initialization complete.
Router>
Step 4
Enter privileged EXEC mode:
Router>
enable
Router#
Step 5
Verify the initial configuration. See the
“Verifying the Initial Configuration” section on page 8
verification procedures.
For more information on using the CLI for router configuration, see the
Using the Cisco IOS Command-Line Interface
section, available at this URL:
http://www.cisco.com/en/US/docs/routers/access/1800/1841/software/configuration/guide/b_cli.html
Содержание 2800 Series
Страница 64: ...22 Basic Software Configuration Using the Cisco IOS Command Line Interface OL 5593 01 Additional References ...
Страница 125: ...Easy VPN Configuration Example Configure 5 OL 6340 01 Private IP address pool 192 168 3 0 24 ...
Страница 138: ...Easy VPN Configuration Example Related Information 18 OL 6340 01 ...
Страница 140: ...Easy VPN Configuration Example Related Information 20 OL 6340 01 ...