Operation
3-8
Roadster & Mirage S+/HD User Manual
020-100002-04 Rev. 1 (12-2008)
Input 1
Press
Input 1
to display from the data input source connected to BNCs labeled
INPUT 1.
If PIP
is enabled,
pressing this key will change the PIP source.
Input 2
Press
Input 2
to display from the DVI source connected to
INPUT 2
. If PIP
is enabled,
pressing this key will change the PIP source.
Input 3
Press
Input 3
to display from the composite video source connected to
INPUT 3
. If PIP
is
enabled,
pressing this key will change the PIP source.
Input 4
Press
Input 4
to display from the S-video source connected to
INPUT 4
. If PIP
is
enabled,
pressing this key will change the PIP source.
Input 5
Press
Input 5
to display from the
INPUT 5
interface module installed in the Option 1. If
PIP
is enabled,
pressing this key changes the PIP source. If there are two inputs
connected here, such as if the Dual SD/HD-SDI module is installed, the second input
(B) is considered
INPUT 7.
Press
INPUT 5
to access
INPUT 7
as follows:
•
While displaying from
INPUT 5
, press
Input 5
again. This switches to
INPUT 7
.
•
While displaying from any input
other
than the
Dual SD/HD-SDI Module
, press
Input 5
. This switches to either
INPUT 5
or
INPUT 7
, depending on which of the
Dual
Module
inputs (A or B) was last used. Press
Input 5
again to display from the other
Dual SD/HD-SDI Module
input.
Input 6
Press
Input 6
to display from the
INPUT 6
interface module installed in the Option 2. If
PIP is enabled, pressing this key changes the PIP source. If there are two inputs
connected here, such as if the Dual SD/HD-SDI module is installed, the second input
(B) is considered
INPUT 8
. If you are using the built-in keypad or the remote keypad,
press
INPUT 6
to access
INPUT 8
as follows:
•
While displaying from
INPUT 6
, press
Input 6
again. This switches to
INPUT 8
.
•
While displaying from any input
other
than the
Dual SD/HD-SDI Module
, press
Input 6
. This switches to either
INPUT 6
or
INPUT 8
, depending on which of the
Dual
SD/HD-SDI Module
inputs (A or B) was last used. Press
Input 6
again to display
from the other
Dual SD/HD-SDI Module
input.
Input
NOTE:
Available on “brick” rental staging keypad only.
Enter
Input
n
(where
n
= 1, 2, 3, 4, 5, 6, 7 or 8) as an alternative method for
selecting which source to display. Six source locations are identified with input
numbers on the projector’s input panel. The last two, 7 and 8, require the
Dual
SD/HD-SDI Module
installed in either of the option slots.
Input 1
Input 2
Input 3
Input 4
Input 5
Input 6
Input