Chicago Dryer King Edge VAc, Инструкция по эксплуатации

Страница: 194 / 302

Repair King Edge Vac
7-60
Left Spreader Clamp Air Pressure
Adjustment
If flatwork is being damaged because the
spreader clamps are gripping too tightly, or if the
clamps are dropping flatwork prematurely, the
problem can be addressed by adjusting the left
spreader clamp air cylinder air pressure.
In addition, adjustments may be required based
on the weight of flatwork being processed.
Required Tools
thin slotted screwdriver
Perform only when the unit is OFF
with power disconnected.
Turn power OFF at the main disconnect
switch.
Turn ON the compressed air supply to
the unit.
Locate the right pneumatic panel (Figure
7-84) just to the right of the center of the
machine.
On the bottom of this unit is the main
solenoid valve. Locate the override screw
on this valve (Figure 7-85).
Use a small screwdriver. Push the screw
in and turn it 1/4 turn clockwise to lock
it down. This lets compressed air into the
system, allowing adjustment with air pres-
sure in the system.
Locate the override screw on the left
spreader clamp solenoid air valve (Figure
7-86, A).
With a small screwdriver, push the screw
in and turn it 1/4 turn clockwise to lock
it down. This lets compressed into the
regulator.
1.
2.
3.
4.
5.
6.
7.
Figure 7-84: The pneumatic panel is mounted near
the center of the unit.
Figure 7-85: Override screw for air solenoid valve
located under pneumatic panel.
Figure 7-86: Left spreader clamp air controls in the
left, center of the machine.
A
B
TOC INDEX