Chicago Dryer King Edge VAc, Инструкция по эксплуатации

Страница: 146 / 302

Repair King Edge Vac
7-12
On the bottom of this unit is the main
solenoid valve. Locate the override screw
on this valve (Figure 7-15).
Use a small screwdriver to push in the
lockout screw and turn it 1/4 turn clock-
wise to lock it in the “in” position. This
allows compressed air to flow to the
transfer clamps.
Move into the middle of the machine.
Use care.
On the inside back wall, locate the sole-
noid air valve for the transfer clamp being
tested left (Figure 7-16, A) or right (B) and
locate its lockout screw.
Use a small screwdriver to push in the
lockout screw and turn it 1/4 turn clock-
wise to lock it in the “in” position. This al-
lows compressed air to flow to the specific
transfer clamp jaw.
Check the transfer clamp:
Look for a gap between the clamp jaw
and the clamp body.
Pull on the clamp jaw to check that it
is firmly closed and to see if there is
any free play.
4.
5.
6.
7.
8.
9.
•
•
As appropriate:
If there is a gap in the clamp, or if it is
not firmly closed, it needs adjustment.
Continue to the Adjusting the Clamps
procedure next.
If there is no gap and it is firmly closed,
no adjustment is necessary.
Release the solenoid lockout screw
from Step 8 by turning it 1/4 turn
counterclockwise.
Release the main solenoid lockout
screw from Step 5 by turning it 1/4
turn counterclockwise.
Turn OFF the compressed air
supply.
Turn power OFF at the main dis-
connect switch.
10.
•
•
1)
2)
3)
4)
Figure 7-15: Override screw for air solenoid valve
located under pneumatic panel.
Figure 7-16: The transfer clamp air valve solenoids
are located on the back wall.
A
B
TOC INDEX