Chicago Dryer King Edge VAc, Инструкция по эксплуатации

Страница: 154 / 302

Repair King Edge Vac
7-20
Route the belts around the timed drive
pulley in the upper right endframe and
around the timed idler pulley in the upper
left endframe.
Use the second bracket to secure the other
two ends of the belt. Manually pull the
two belt sections tight before completely
tightening the bracket bolts.
Secure the ends with plastic wire ties.
Remove the C-clamps placed in Step 3.
Follow the Upper Spreader Belt Ten-
sion Adjustment
procedure earlier in
this section.
Replace and secure both upper endframe
panels.
12.
13.
14.
15.
16.
17.
Upper Spreader Clamp Grooved
Bearing Replacement
These bearings usually wear down in pairs,
either both upper or both lower. Even if only
one bearing shows signs of excessive wear,
replacement should still be done in pairs.
Required Tools
13 mm metric wrench, 5 mm metric
Allen key, 7/16” wrench, 3/16” Allen
key, Phillips screwdriver, clean cloth
Perform only when the unit is OFF
with power disconnected.
Turn power OFF at the main disconnect
switch.
Remove the two metric bolts which secure
the spreader clamp carrier assembly to the
linear bearing assembly block (Figure 7-
27). One bolt is longer than the other. Note
its position for correct reassembly at the
end of this procedure.
Remove the two screws (Figure 7-28, A/B)
which secure the upper rail to the unit.
Remove the upper spreader rail from the
unit and slide the bearing block off the rail.
Place both on a work table.
1.
2.
3.
4.
Figure 7-27: After removing these bolts, let the
spreader clamp carrier assembly rest
on the air foil.
Figure 7-28: Two screws secure the upper rail to
the unit.
A
B
TOC INDEX