Chicago Dryer King Edge VAc, Инструкция по эксплуатации

Страница: 23 / 302

King Edge Vac Installation
2-5
Move the unit into final position in front
of the ironer.
Figure 2-5 shows the desired relative
positioning of the bypass conveyor and
the discharge conveyor idler rolls to the
ironer inlet.
Use the stop nut (Figure 2-4, B) to adjust
the height of the bypass conveyor. Tighten
down the locknut (Figure 2-4, C) to secure
the position.
If necessary, adjust the positioning of the
discharge conveyor by turning its posi-
tioning bolt (Figure 2-6, A). Secure the
adjustment with the stop nut (B).
NOTE: Secure the unit to its
foundation if required by local
code. Always follow local codes.
Set the locking casters.
Attach the provided locking floor pads to
the front crossbar (Figure 2-7, A). There is
one for the left and one for the right side
of the machine.
Adjust each pad so that it will rest firmly
against the floor when fully extended
(Figure 2-7, B). Secure the adjustment by
tightening the locking nut (C).
Push the locking lever (Figure 2-7, D)
fully down to extend the pads and firmly
secure the unit in position.
8.
9.
10.
11.
12.
13.
14.
15.
Ironer inlet
Bypass
conveyor
Discha
rge
conv
eyor
Figure 2-5: Position the bypass exit conveyor so
that it is just slightly higher than the
ironer inlet.
Figure 2-7: The locking floor pads help secure the
unit in position.
A
B
C
D
Figure 2-6: Discharge conveyor positioning bolt.
A
B
TOC INDEX